Converting a bus into a motorhome

Gas cylinder and stove:

holdInitially, I planned to build a propane cupboard under the bus, because I didn't want to waste valuable cargo space.

However, splitting an existing recess is much simpler, therefore the KISS principle requires its use.

bottles noThe two bottles fit nicely when the top of the recess is cut out.
recess partitionThe partition is attached with sheet metal screws and “I breathed” the bottom of the cavity by making two holes with a cutting torch.

They will be a foam seal between the cargo and the gas plant.

The partition consists of several bolted steel shelves. I think, that they come from the place, where I worked in the mid eighties!

Bottles in the bayHere is one bottle in place and connected to the regulator.
The seat belt has a propane tankI used one of the old seat belts to secure the tanks.
black iron pipeThere is a black iron pipe outside the bus, which, after entering the living area, turns into a copper pipe.
bending copper pipesI used a piece of computer power cord as a stem, to make a sharp bend of the copper tube.
torch tubeTo prepare the end of the tube, you need to use a special tool, to extend it. Don't forget to put on the nut first!

Home Depot has a flaring tool, pipe and tube. The flaring tool cost approx 20 dollars.

copper pipesGuiding the tube through the stove cabinet.
furnace mountingThe furnace slides in and the tube connects to the fitting on the manifold.

The stove is from Timbuckt , my local caravan shop. It cost approx 350 dollars.