Used cars
Float position adjustment
The float position must only be adjusted when the needle valve or the float is replaced.
■ Set the carburetor cover to the position shown in the illustration 2.177. The ball of the valve needle sits flexibly in the needle – belongs …
Idle adjustment on a cold engine (opening the throttle)
If the engine idles constantly, it is most often the "fast" idle that needs to be adjusted. Before making adjustments, warm up the engine to operating temperature. Ignition settings and gear speed …
Keihin II carburetor adjustment
The expense of the accelerating pump:
A measuring cylinder is required to measure the flow rate (measuring cup) and funnel.
■ Remove the carburetor.
■ Remove the carburetor cover.
■ Fill the float chamber with fuel.
■ Reinstall the cover.
■ Docisnąć …
Keihin II carburetor repair
In the drawings 2.169, 2.170 i 2.171 shows the carburetor in parts.
When repairing the carburetor, follow the instructions on the page 136. The carburetor can be disassembled in the following order.
■ Remove the split pins (4, lynx. 2.169). of the rod ends (6), …
Keihin II Carburetor Removal and Installation
The design and principle of operation of the Keihin I and Keihin II carburetors are similar to each other. The figure shows the carburetor mounting components.
Lynx. KEIHIN II CARBURETOR MOUNTING DETAILS
1 – Keihin II carburetor
2 – tributary …
Float position adjustment
The position of the float must only be adjusted when the needle valve or the float is replaced.
■ Set the carburetor cover to the position shown in the illustration 2.165. The ball of the valve needle sits flexibly in the needle – need caution, so that the ball does not stay …
Idle adjustment on a cold engine (opening the throttle)
If the engine idles constantly, it is most often necessary to adjust "fast” Idle. Before making adjustments, warm up the engine to operating temperature. Ignition settings and idle speed must be correct.
■ …
Keihin I carburetor repair
Drawing 1. KEIHIN I CARBURETOR ASSEMBLY DRAWING (carburetor cover)
1 – regulating valve
2 – suspension of the float valve needle
3 – carburetor cover
4 – carburetor cover bolt
5 – pull-down actuator”
6 – pump lever …
Keihin I Carburetor Removal and Installation
List of carburetors and engines, in which the carburetors are mounted, can be found in the table "Technical characteristics”. The carburettors used are of the two-hole type 26-30 DC. The carburetor is equipped with actuators to control the automatic starter and the opening device …
Most of the maintenance work can be done independently. However, it is often better to carry out some activities at a service station. These include activities, for which special tools are necessary, experience or measuring instruments, and activities, which the service station can do faster.
Listed below, …